Emc; Telecommunications; Ce Marking - Ericsson RX8000 Series Reference Manual

Annex B
B.9.2

EMC

The equipment has been designed and tested to meet the following:
EN 55022
and
CISPR22
EN 61000-3-2
EN 61000-3-3
EN 55024
FCC
B.9.3

Telecommunications

If certain Option Modules (telecom interfaces) are fitted, this equipment comes
within the scope of the RTTE Directive, 1999/5/EC. Compliance with the applicable
essential requirements of this Directive (safety and EMC) are met by conformance
with the safety and EMC standards listed above.
B.9.4

CE Marking

The CE mark is affixed to indicate compliance with the following directives:
DIRECTIVE 2006/95/EC OF THE EUROPEAN PARLIAMENT AND OF THE
COUNCIL of 12 December 2006 on the harmonisation of the laws of Member
States relating to electrical equipment designed for use within certain voltage
limits.
8
The EMC tests were performed with the Technical Earth attached, and configured using recommended cables.
9
Applies only to models of the Product using AC power sources.
B-22
8
European
International
European
9
9
European
European
USA
Emission Standard
Limits and methods of measurement of radio
frequency interference characteristics of
information technology equipment - Class A.
Electromagnetic Compatibility (EMC), Part 3
Limits; Section 2. Limits for harmonic current
emissions (equipment input current ≤ 16 A
per phase).
Electromagnetic Compatibility (EMC), Part 3.
Limits; Section 3. Limitation of voltage
fluctuations and flicker in low voltage supply
systems for equipment with rated current ≤
16 A.
Information technology equipment - Immunity
characteristics - Limits and methods of
measurement.
Conducted and radiated emission limits for a
Class A digital device, pursuant to the Code
of Federal Regulations (CFR) Title
47-Telecommunications, Part 15: Radio
frequency devices, subpart B - Unintentional
Radiators.
EN/LZT 790 0005 R1A