Defaults; Reset To Factory Defaults - Emulex NJ01B-NT+ User Manual

Reset to Factory Defaults

Before resetting to factory defaults, we recommend that you print out a
configuration page. Using the command described below will reset the
printer server to its factory defaults.
•
The printer server will reset to factory defaults when power is cycled.
•
The IP address and subnet mask are reset to NONE (000.000.000.000).
•
Non-volatile memory is reset to factory defaults.
To reset to factory defaults:
1) Obtain privileged status.
2) Enter this command:
>
Server>> initialize [server] [delay delay_min]
[default]
delay
delay_min
default
3) Cycle printer power.
Printer Server Installation 2-33
Indicates reintialization will not take place until after a
specified period of time.
Specifies the time before the server is stopped and
the initialization process begins. The default is 1
minute.
Resets the server to factory defaults