Emulex NJ01B-NT+ User Manual page 130

5-2 Chapter 5
>
LATCP> set port lta901:/application/node=
server_name /port=port_n
server_name The Emulex default server name from the Before
port_n
Be sure to match the case (upper/lower) of the node and port names.
>
LATCP> exit
2) Verify LAT port maps to the Emulex printer server correctly.
>
$ copy/log FILENAME ltaNNN:
If an error occurs, verify configuration in step 1.
3) Set up the terminal parameters:
>
$ set terminal lta901: /perm/device=unknown
/width=80 /page=66 /lowercase /nobroadcast
>
$ set protection=(s:rwlp,o,g,w:rwlp)/device lta901:
>
$ set device lta901: /spooled=(queue_name,
sys$sysdevice:)
queue_name
4) Initialize each printer queue for text documents:
>
$ initialize /queue /start /processor=latsym
/retain=error /on= lta901: /default=(noburst,
flag=one, notrailer, nofeed) /record_blocking
queue_name
queue_name
5) Initialize each printer queue for PostScript documents:
>
$ initialize /queue /start/processor=latsym
/retain=error /on=lta901:/default=(noburst,noflag,
nofeed, notrail) /record_blocking
queue_name
Installation section of this chapter.
The printer server parallel or serial port number.
The name given to the printer queue.
The name given to the printer queue.
The name given to the printer queue.
queue_name