Print Test Page; Print Configuration Parameters - Emulex NJ01B-NT+ User Manual

Print Test Pagearameters
The test pageparameter printout
connection between the printer server and the printer. The test page contains
the following
reference when configuring the printer server. The print out contains
default and recently changed informationPrinter
DDefault remote pPrinter nName
Hardware & fFirmware revisions
SSoftware revision
To print the test page, perform the following steps:
1) Verify printer has power and is On-Line.
2) Turn the printer OFF.
3) Disconnect the LAN cable.
4) Turn printer ON.
5) Verify the printer is On-Line.
6) The printout will occur within 90 seconds.
If no printout occurs, make sure printer shows power ON, Ready and On-
Line. Verify printer server installation and try printing test page again.
NOTE: If the printer is PCL or text only, the test printout

Print Configuration Parameters

To obtain a printout of configuration parameters, enter this software
command:
>
Server>> show server config port port_num [ps]
port_num
ps
is a useful
data:
may contain PostScript commands.
The output is directed to the specified port number.
Puts the output in PostScript format.
Printer Server Installation 2-7
tool that can be used to verify the
sServer nName
MAC Address
Node Nname
NOS iInformation
Network pProtocols