7) Gently press the board into position.
8) Tighten the two captive screws.
The captive screws are located on the face of the Emulex printer server.
Tightening these screws will secure the printer server to the printer.
LAN Connections & Cabling
The printer server may be connected to the network with one of these cables.
•
Unshielded twisted-pair (UTP) with an RJ-45 connector
•
Thinwire with BNC connector and BNC T-adapter
CAUTION: Do not connect network cables to both the
Unshielded Twisted-Pair Connection
1) Connect one end of the UPT cable to the printer server UTP port.
See Appendix for UTP pinout details.
2) Connect the other end of the UTP cable to the network.
3) Do not connect anything to the printer server BNC port.
BNC and the UTP ports on the printer server
at the same time.
Twisted Pair
Connector
CONSOLE
UTP
Figure 2-2: Printer Server LAN Connections
Printer Server Installation 2-3
NETJet
MAC ADDRESS
00-00-C9-01-A0-6A
1
2
BNC
Thin Wire
Connector