Before Installation; Lan Server - Emulex NJ01B-NT+ User Manual

Before Installation

We recommend writing down the following parameters from the Setup
Section in Chapter 2. Refer to them during the installation procedure.
Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____
Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___
IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___
TCP port _______ (parallel port)
TCP port _______ (serial port)
Telnet port number _______
Have the TES & LAN Server diskette or the CD-ROM ready for installation.
LAN Server Prior to 4.0
Check the system configuration before installing Print Manager for TCP/IP
printing. Every server and client must have the TCP/IP stack loaded before
the server or client can send a print job to the printer server.
Verify OS/2 LAN Server is installed with the TCP/IP protocol stack.
1) Verify that a directory containing TCP/IP libraries and applications
exists on the system.
2) If this entry is not present, refer to the LAN Server documentation for
information on installing and enabling the TCP/IP protocol stack.
Verify the network interface card (NIC) is configured for TCP/IP.
3) Run the LAN Adapter and Protocol Support Utility.
4) Select C
5) In C
URRENT
should be listed under each appropriate adapter or interface card (NIC).
6) If this entry is not present, refer to LAN Server documentation for
information on how to configure and enable the TCP/IP protocol stack.
NOTE: NetBios does not need preinstallation chekout.
.
ONFIGURE
C
ONFIGURATION
TCP port _______ (parallel port)
TCP port _______ (serial port)
RCF port number _______
box, an entry for IBM TCP/IP protocol

LAN Server 8-3