Dhcp - Emulex NJ01B-NT+ User Manual

4-8 Chapter 4
4) Enter Emulex printer server command:
>
Server>> define server bootp n m [temp]
n
m
temp

DHCP

If the UNIX host is configured as a DHCP server, the IP address is assigned
automatically.
NOTE: The Emulex printer server must always be
1) Login to the Emulex printer server.
2) Enter:
>
Server>> define server DHCP n m [temp]
n
m
temp
NOTE: If both n and m are zero, DHCP is disabled.
The number of times to request BootP information if
the server IP address is not known (default = 2).
The number of times to request BootP information if
the server IP address is known (default = 1).
Instructs the server to configure the acquired
information in RAM only. If this parameter is
omitted, the information is permanently written in
EAROM (default is permanent).
configured as "reserved" client by the host DHCP
administration facility. This guarantees that an IP
address assigned by DHCP will be reserved
exclusively for that printer server through its LAN
hardware address.
The number of times to request DHCP information if
the server IP address is not known (default = 2).
The number of times to request DHCP information if
the server IP address is known (default = 1).
Instructs the server to configure the acquired
information in RAM only. If this parameter is
omitted, the information is permanently written in
EAROM (default is permanent).