Defaults; Reset Using Status Button; Reset Using Status Button; Reset Using Software Commands - Emulex NJ01B-NT+ User Manual

Reset to Factory Defaults

Before resetting to factory defaults, we recommend that you print out a
configuration page. Two methods can be used to reset the printer server to its
factory defaults.
•
Using the status button
−
The printer server will reset to factory defaults immediately.
−
IP address and subnet mask are reset to NONE (000.000.000.000).
−
Non-volatile memory is reset to factory defaults.
•
Using a software command
−
The printer server will reset to factory defaults when power is cycled.
−
IP address and subnet mask are reset to NONE (000.000.000.000).
−
Non-volatile memory is reset to factory defaults.

Reset Using Status Button

1) Remove AC power cord from the printer server.
2) Depress status button and hold.
3) Reconnect AC power cord to printer server, then release status button.

Reset Using Software Commands

1) Obtain privileged status.
2) Enter this command:
>
Server>> initialize server delay delay_min default
delay
delay_min
default
Printer Server Installation 2-21
Indicates reintialization will not take place until after a
specified period of time.
Specifies the time before the server is stopped and
the initialization process begins. The default is 1
minute.
Resets the server to factory defaults