Support Axle - Duerkopp Adler 745-26 Service Instructions Manual

4.5 Support Axle

4 5
Prerequisite for the setting of the piping support, gripping folder and
marker lights is the parallel positioning of the support axle 1 to the
reference line 2.
1
Caution Risk of Injury !
Turn the main switch off.
Set the support axle only with the main switch turned off.
–
Set the stopper screw 4.
With the folding station swung in, the ball knob 5 should catch
securely with its arresting pin.
–
Check the parallelity of the support axle 1.
Move the stopper angle 3 onto the the support axle at the front and
back and check the dimension to the reference line 2.
If the dimensions are not the same, then the folding station must
be aligned again.
–
Loosen screws 7 ( 2-off ).
–
Align the folding station with support axle 1 again by moving the
block 6.
–
Tighten screws 7 ( 2-off ) again.
6 7
ATTENTION !
If the support axle was realigned, then the gripping folder, piping seat
and the marker lights must also be set again.
2 3
21