3
9
4
86
10
5
6
Caution Risk of Injury !
Danger of injuries from cuts!
When working on the needle holders 5 keep hands clear of the area of
the center knife 9.
–
Under the needle holders 5 press the needle bar to be switched off.
At the same time turn the handwheel backwards.
The needle bar switches off.
–
Bring the needle bar into the looping stroke position
(see Chapter 15.6).
–
Insert the timing pin 10 through the hole in the machine arm.
The timing pin 10 must catch in the groove of the arm shaft crank.
–
Push the setting pin 6 into the needle holders 5 up to the stop.
–
Tighten screw 13.
–
Screw out screw 11.
–
Turn the needle holders 5 downward.
The measuring bridge 4 should allow itself to be pushed under the
setting pin 6 with least possible play.
–
If necessary, turn the needle holders 5 back (higher) accordingly.
The front surfaces 12 of the needle holders 5 must hereby face
forward and lie at one level.
–
Screw screw 11 into the needle holders 5 and tighten.
–
Remove the timing pin 10 and setting pin 6.
–
Remove spacer 3.
11
12
13