Duerkopp Adler 745-26 Service Instructions Manual page 55

S100
1
3 4
–
Conduct a sewing trial.
The seam beginning and seam end must lie symmetric to the flap.
The first stitch should lie in front of and the last stitch behind the
flap edge (see illustration a).
–
In case of seam sketch b) or c) loosen screws 7.
–
Slide light barrier S100 counter to or in the direction of transport
until the position of the seam as per illustration a is achieved.
–
Tighten screws 7.
–
Fine tune the seam length with the correction values for the light
barrier at the seam beginning and seam end (see Short
Description DAC Chapter 5.3).
2 S100
5 6
a)
S100 7
b) c)
55