7
8
9
10
11
12
13
Position the seat in the direction of sewing
–
Loosen screws 7 and 13.
–
Move the bracket 9 on the axle.
The clearance between stopper angle 3 and the forward-lying
needles is 228 mm.
–
Move the set collars 8 and 10 onto the bracket 9.
–
Tighten screws 7 and 13 again.
Setting with the piping seat at the left
The cylinder 16 is in the forward position on the plate 18 (piston rod
retracted).
–
Loosen lock nut 12.
–
Set the stopper screw 11.
The clearance between stopper angle 6 and the reference line 5
is 131 mm.
–
Tighten lock nut 12 again.
Setting with the piping seat at the right
The cylinder 16 is in the rear position on the plate 18 (piston rod
extended).
–
Loosen screws 17 ( 2-off ).
–
Set the plate 18 with cylinder 16.
The clearance between stopper angle 6 and the reference line 5
is 131 mm.
–
Tighten screws 17 ( 2-off ) again.
14
15 16
17
18
23