Bobbin Winder - Duerkopp Adler 745-26 Service Instructions Manual

15.18 Bobbin Winder

The winding procedure must end automatically when the bobbin is
filled up to approx. 0.5 mm in front of the edge.
1 2
Caution Risk of Injury !
Turn the main switch off.
Set the bobbin capacity only with the main switch turned off.
Correcting the bobbin capacity
–
Remove the bobbin winder cover 3 after loosening the mounting
screws.
–
Loosen clamping screw 2 slightly.
–
Set the bobbin capacity by turning the switching cam 1.
Turning in direction of the arrow A: Decrease bobbin capacity
Turning in direction of the arrow B: Increase bobbin capacity
–
Tighten clamping screw 2.
–
Attach the bobbin winder cover 3 again.
3
103