1
2
3
4
5
3
4
8
–
Turn the handwheel until the swing lever 9 reaches its farthest
swing to the back (in direction of the arrow).
–
Turn swing lever 9 on the shaft 11 so that the tappet 10 of the latch
is still just pushed off the catch 1.
–
Tighten clamping screw 13.
–
Attach all removed parts (head cover, cylinder with swing lever for
the thread puller) again.
Position of the needle bars to the center knife:
–
The needle bars must move counter to the center knife. With the
needles lying low the drive lever 12 must lie at its upper dead
center.
–
It is essential to conduct a precise setting as per Chapter 15.13.
9
1
10
9
11
12
13
6
7
75