Replacing Corner Knives (745-26) - Duerkopp Adler 745-26 Service Instructions Manual

12.2 Replacing Corner Knives ( 745-26 )
62
Blunt corner knives are to be replaced by a knife set to be found in the
accessories pack.
Please see Chapter 1 of these service instructions for the order
numbers of the corner knife sets.
Caution Risk of Injury !
Turn the main switch off.
Replace the corner knives only with the main switch turned off.
Danger of injuries from cuts!
Keep hands clear of the sharp blades of the corner knives.
–
Screw the screw 5 out.
–
Pull the knife bracket 4, complete with corner knives 2 and the
awl 1, from the knife bar.
–
Screw the knife bracket 4 into a vise for secure working.
–
Loosen clamping screw 3.
The clamping collar in knife bracket 4 is loosened.
–
Remove the awl 1 and both corner knives 2.
–
Insert new corner knives into the slits in the knife bracket 4.
Attention!
The angle-ground blades must face to the outside.
–
Insert the awl 1 into the hole provided.
–
Push both corner knives into the knife bracket 4 up to the stop.
Hereby bring the corner knives to the back until they touch the awl
1.
–
Tighten clamping screw 3.
–
Insert the knife bracket 4 onto the knife bar up to the stop.
–
Tighten screw 5.
1
2
3
4
5