1
2
3
4
5
64
Setting the awl rod and the knife bars
The setting oocurs with a gauge ( Order no. see Chapter 1, side 4 ).
–
Remove screws 7 and loosen 14 and 15.
–
Remove the clamping piece 9, corner knives and awl 6.
–
Loosen clamping screw 2 and 12 and the adjusting screws 3 of the
forked pieces 1.
–
Insert gauge 4 in the groove of the awl rod and tighten screw 14
and 15.
–
Set the forked pieces 1 and tighten screws 16.
The knife bars should be guided tight but still have ease of
movement.
To check: Detach the draw springs 17 and 18.
–
Set the awl rod 19 and tighten screws 12.
When the forked piece 11 is in its lower rest position the gauge 4
should touch on the catch lever 13.
–
Set the knife bar.
The top edges of knife bracket 5 and the gauge 4 should be
uniform.
–
Align knife bracket 5.
The knife bracket 5 should lie parallel to the outer edges of the
gauge 4.
Turn the awl rod and knife bars accordingly.
–
Tighten clamping screws 2 and 12 again.
–
Check the ease of movement of the knife bars and the awl rod.
6
7
8
9
10
11
12
13
14
15
16
17
18
19