16.3 Length-Controlled Feed and Trimming Device for Reinforcement Strips
1
2
3
The length-controlled feed and trimming device for reinforcement
strips (Order no.: 0794 014301) is used e.g. when sewing inner and
outer jacket pockets.
Caution Risk of Injury !
Turn the main switch off.
Set the feed and trimming device only with the main switch turned off.
Setting the clamp-on pressure
During of the advance the clamping plate 1 operated by cylinder 4
holds the reinforcement strip clamped.
During the transport and sewing sequences the clamping plate 1 is
raised.
–
Loosen lock nut 3.
–
Set the clamp-on pressure of the clamping plate 1 by turning the
stopper screw 2.
The reinforcement strips must still just be securely transported.
–
Tighten lock nut 3.
Setting the tape length
The tape length is set at the controls.
–
Activate the pocket program.
See Short Description DAC Chapter 5.5.
4
109