7.1 Feed for Pocket Bags
1
2
3
4
38
The feed brings the pocket bags securely to the center of the pocket
opening of the folder.
Caution Risk of Injury !
Turn the main switch off.
Set the feed only with the main switch turned off.
Conduct setting work with the sewing machine running only while
exercising the greatest possible caution.
6
7
Setting the position the take-up rail
The take-up rail should run to the center of the pocket opening and at
this point lie approx. 2 - 3 mm over the sewing piece.
–
Loosen screw 1.
–
Set the take-up rail 4 by turning the shaft 2.
–
Tighten screw 1.
Setting the position of the table
Set the position of the table 7 so that the gripper needle rows of the
take-up rail 4 enter in the center of the sponge rubber 6.
–
Loosen screws 8 and 9.
–
Move table 7.
–
Tighten screws 8 and 9.
5