14. Setting the Cloth Slider Plate and Feed Plate
Align the cloth slider plate 1 so that its recess has the same clearance
to both sides of the needle plate elevation.
The feed plate 4 must build one level with the base plate of the
machine head.
Caution Risk of Injury !
Turn the main switch off.
For safety reasons the cloth slider plate 1 is only released in the
transport carriage end position and with the main switch turned off.
–
Remove the cloth slider plate 1 (see Operating Instructions).
–
Loosen screws 2 slightly.
–
Set the cloth slider plate 1 forward by moving the mounting plate 3.
–
Tighten screws 2 again.
–
Set the feed plate 4 at one level with the table top at the back by
turning the adjusting screw 5.
–
Set the feed plates 4 at one level with the table top at the front by
turning adjusting screws 6 ( 2-off ).
69