10. Height of the Cloth Clamps
1
Caution Risk of Injury!
Set the height of the cloth clamps only in the "Safe Stop" position or
with the machine turned off.
Rule and Control
The height of the cloth clamps 2 must be set so that the clearance
between the open upper cloth clamps 2 and the lower cloth clamps
(pos. 3) is 10 mm.
E.g. place a drill bit with a diameter of 10 mm between the cloth
–
clamps in order to check the clearance.
Correction
Loosen nut.
–
Set the screws 1 on the cloth clamps accordingly.
–
Tighten the nut.
–
2
3
4
17
3