23. Thread Take-up Disk
3
4
34
Rule and Control
Insert a positioning pin into the drilled hole 5 of the sewing machine
–
and arrest the sewing machine in the stake-out position. The looper
support must be in the left end position thereby.
Insert a pin (2 mm diameter) or the shank of the needle through the
–
drilled hole 2 in the thread take-up disk.
The pin must touch on the right side of the thread guide 1.
–
Caution Risk of Injury!
Set the thread take-up disk only in the "Safe Stop" position or with the
machine turned off.
Correction
Loosen screws 3 and 4 on the toothed belt sprocket.
–
Turn the thread take-up disk so that the rule is fulfilled.
–
Tighten screws 3 and 4.
–
1
2
5