Data For Several Subclass/Equipment/Cutting Length - Duerkopp Adler 579 Service Instructions Manual

33.16.2 Data for several Subclass/Equipment/Cutting Length

All data (Buttonhole programs and Sequences) for the available
Subclass/Equipment/Cutting Length will be listed.
Important:
The current Subclass/Setup will not be listed, which means the data
cannot be deleted.
Select the Subclass/Setup to be deleted with the arrow keys.
–
Press the "OK" key. The confirmation screen menu beside appears:
–
After confirming with the arrow key "ð" for "Yes" a mark appears on
–
the right of the number.
You can select simultaneously several Subclass/Setup.
After selecting the sequences to be deleted press the "ESC" key.
–
You will exit the menu.
The machine will display the Subclass menu again.
You can now shift the subclass.
ATTENTION !
After changing the subclass, always check the position of the
eye knife (see Chapter "Eye Knife") before sewing a buttonhole.
Since the position of the eye knife is different with the various
subclasses, it can cause damage to the machine when the position
of the eye knife is not correctly set.
3
69