Setting The Feed Position; Setting The Eye Inclination; Total Piece Counter - Duerkopp Adler 579 Service Instructions Manual

33.12 Setting the Feed Position

33.13 Setting the Eye Inclination

33.14 Total Piece Counter

62
The feed position can be established here. The following values can be
set:
When you are in the service menu, sequentially select the following
menu items with the arrow keys and the "OK" key:
- Configuration
- Machine
The "Machine" menu appears.
1 = The material is fed at the position for cutting a buttonhole.
2 = The material is fed at the seam beginning position
Select " Feed Position W0" with the arrow keys.
–
Press the "OK" key.
–
Change the value for the feed position with the arrow keys.
–
Press the "OK" key.
–
This allows the setting of the incline of the buttonhole eye in regard to
the straight part of the buttonhole.
The entry range lies between -10° and +10°.
When you are in the service menu, sequentially select the following
–
menu items with the arrow keys and the "OK" keys:
- Configuration
- Machine
The "Machine" menu appears.
–
With the arrow keys select "Eye incl." .
–
Press the "OK" key.
–
With the arrow keys change the value for the eye incline.
–
Press the "OK" key.
–
The total piece count for the machine is displayed in the lowest line of
the "Machine"menu. This counter cannot be reset.
When you are in the service menu, sequentially select the following
–
menu items with the arrow keys and the "OK" key:
- Configuration
- Machine
The "Machine" menu appears.
–
The bottom line displays the amount of pieces counted.