Cutting Block Setting; Cutting Pressure - Duerkopp Adler 579 Service Instructions Manual

13.3 Cutting Block Setting

13.4 Cutting Pressure

1
2
3
Caution Risk of Injury!
Set the cutting block only in the "Safe Stop" position or with the
machine turned off.
Rule and Control
The cutting block must lie parallel to the cutting knife.
Correction
Loosen screw 1.
–
Turn cutting block 2 with the guide.
–
Tighten screw 1.
–
Rule and Control
In order that all components be subjected to minimal stress and to
increase the idle period of the cutting knife, the cutting pressure can be
set.
Dependent on the sewing material and material thickness, the cutting
pressure should be set as low as possible. It must be set strong
enough so that the material is still securely cut. The pressure is set at
4 bar at the factory.
Correction
Set the desired pressure with the pressure regulator 3.
–
3
25