26.2 Setting the Overlap of the Knife
X
Caution Risk of Injury!
Set the long trimmer only in the "Safe Stop" position or with the
machine turned off.
Rule and Control
The blades 1 and 2 must move approx. 1 mm over one another.
It must be possible to insert the clamping plate without clamping.
The roller 7 must grip in the throat of the link 5.
Remove the right clamping plate.
–
Insert the right clamping plate again.
–
It must be possible to insert the clamping plate without clamping.
Correction
Setting the throat
Loosen screw 4.
–
Move link 3 on the piston rod.
–
The dimension X in the illustration should be 39 mm.
Tighten screw 4.
–
Setting the overlap
Loosen clamping screw 5.
–
Turn lever 6.
–
Set it to have the measure 61 mm (see fig. on the left)
Tighten screw 5.
–
Insert the clamping plates.
–
Turn the machine on.
–
Activate the "Output Test" testing program (see "Output Test").
–
Switch output Y8 to "+".
–
Switch output Y10 to "+".
–
Check the size of the overlap.
–
Switch output Y8 to "-".
–
Switch output Y10 to "-".
–
Turn the machine off.
–
1
7
5
2
3
4
6
3
39