Data For One Subclass/Equipment/Cutting Length - Duerkopp Adler 579 Service Instructions Manual

33.16.1 Data for one Subclass/Equipment/Cutting Length

When there is no memory available for further buttonhole shapes
–
or buttonhole sequences, the following menu appears instead of
the confirmation request. It allows you to delete data to free the
memory for the new program data and shifting the subclass.
Too much Buttonhole programs
If you reach the number of 50 buttonhole programs in one
Subclass/Equipment/Cutting Length, the selection menu for deletion
beside appears.
Select the Buttonhole program with the arrow keys.
–
Press the "OK" key.
–
The confirmation screen menu beside appears:
After confirming with the arrow key "ð" for "Yes" a mark appears on
–
the right of the number.
You can select further Buttonhole programs to be deleted.
–
After selecting the Buttonhole programs to be deleted press the
–
"ESC" key.
You will exit the menu.
The machine will display the Subclass menu again. You can now
shift the subclass or create a buttonhole program.
Check the position of the Eye Knife (see Chapter "Eye Knife").
–
Hint:
Delete as much as possible Buttonhole programs, so that you can still
create Buttonhole Programs after shifting the subclass.
ATTENTION !
The number of the remaining buttonhole programs may change after
deleting some of the buttonholes. The data remains unaltered.
Deleting buttonhole programs will remove it as well from the
–
sequence.
Change of buttonhole programs number will also affect the
–
sequence.
3
67