Setting The Needle Bar Parallel To The Looper Turret - Duerkopp Adler 579 Service Instructions Manual

5. Setting the Needle Bar Parallel to the Looper Turret

1
2
3
4
5
6
Caution Risk of Injury!
Set the parallelism of the needle bar to the looper turret only in the
"Safe Stop" position or with the machine turned off.
Rule and Control
The needle bar guide 2 and the looper turret 6 must lie parallel to one
another, that is, screw 1 and the block 4 must lie vertically above one
another.
Check if the block 4 on the looper turret and the screw 1 on the
–
needle bar guide lie vertically above one another.
ATTENTION !
The needle fastening screw 3 must lie to the left.
Correction
Loosen screws 5 on the toothed wheel.
–
Hold the looper turret fast and turn the needle bar guide so that
–
looper turret and swing sleeve lie parallel.
Tighten screws 5 on the toothed wheel.
–
3
11