Calibration "C" Numbers - Cardinal 225 Installation And Technical Manual

CALIBRATION AND SETUP, CONT.
3. Zct=XXXXXXX (ZERO COUNT)
With the SCALE 1 CALIBRATION MENU di
parameter will be shown. Note that XXXXXXX is the current value for the analog to
digital reading at zero, the Zero count. If the setting displayed is acceptable, proceed t
the next setup parameter.
Otherwise, press the 3 key, the ENTER key and then using the num
value for the zero load Zero count and then press the ENT
setting and return to the SCALE 1 CALIBRATION MENU. Allowable values are 1
through 9,999,99
Ca libration "C" Numbers
he calibration "C" numbers (C1, C2, C3 and C4) represent the present calibration
T
settings. Each number m
established when the scale is calibrated. To return the indicator to its pres
settings (without using test weights) enter the calibration "C" numbers.
6. C1=XXX
7. C2=XXX
8. C3=XXX
9. C4=XXX
With the SCALE 1 CALIBRATION MENU displayed the current setting for the C1=,
C2=, C3= and C4= parameters will be shown. N
the calibration "C" number. If the settin
previously, proceed to the next setup parameter.
Otherwise, press the 6, 7, 8 or 9 key, (for the "C" number to be changed), the ENTER
key and then using the numeric keys, enter the value for the "C" number and then p
the ENTER key to save the new setting and re
MENU. Allowable values are 1 through 255.
If any components have been changed that affect calibration and/or the scale is
used in a commercial application and must be "Legal for Trade", calibration
parameters or the "C" numbers cannot be use to re-calibrate.
8200-M538-O1 225 Installation
9. Note that the capacity can not exceed 7 digits or 9,999,999.
ay be up to three (3) digits in length. These values are

CALIBRATION "C" NUMBERS

splayed the current setting for the Zct=
ER key to save the new
ote that XXX is the current value for
gs displayed match the numbers recorded
turn to the SCALE 1 CALIBRATION
o
eric keys, enter the
ent calibration
ress
Page 70