Infrared (Ir) Data Port - Cardinal 225 Installation And Technical Manual

An infrared (IR) data p
front panel of the indicator slightly above and to the right side of the PRINT
N o. 14). NOTE! If not using the IR data port, it is highly recommended to disable it.
The IR por t transmits and
the same s ettings and for
PRINTER port.
To use the IR port , you nee
A computer (such as a desktop or laptop)
or a Personal Digital Assistant (PDA)
equipped with an IR port.
An infrared port drive
computer or PDA to communicate with IR
port in the 225.
App licatio n software
PDA to s end and rec
USING THE IR PORT
1. Make sure the 225 is on and the computer or PDA is ready to communicate.
2. Align the computer w
3. Ens ure tha t the ports
to either the left or right and above and below.
4. Sen d the c ommand
5. The 225 will perform the command (e.g. cha
display) or the data requested will be sent to the computer or PDA.
8200-M538-O1 225 Installation
I NFRARED (IR) DATA PORT
ort is standard on the Model 225 Indicator. The IR port is located on the
r eceives data using
m ats supported by the
d the following:
r that allows the
for the computer or
eive the data.
ithin 3 feet (1 meter) of the IR port.
are facing each other (line-of-sight) with no more than a
to the 225.
Figure No. 14
nge from Gross to Ne
key (see Figure
Infrared
Port
15º angle
t weight on the
Page 102