Setup Scale - Cardinal 225 Installation And Technical Manual

CALIBRATION AND SETUP, CONT.
T he following describes the Scale Setup for the 225. The standard 225 supports on
(1) scale. With the optional 225-DS Dual Scale card installed, it can support up to
three (3) sc ales. In the setup menus shown and parameters described, Scale 1 is
referenced . Substitute the scale number you are configuring for the number sho
SETU P SCALE
With S ETUP MENU #1 displayed, press NEXT (Navigation Keys
SETUP MENU #2.
1. SERIAL
2. DIO
3. PRINT TABS

4. SETUP SCALE 1

5. CALIBRATE 1
Enter Selection: 0
4. S ETUP SCALE 1
With the SETUP MENU #2 displayed, press the 4 key and then the ENTER key to proceed
to S CALE 1 SETUP MENU #1.
1. BASE UNITS=X XX
2. CNVT UNITS=X XX
3. Z TRACK=X.X
4. Z LIMIT=XXX
5. PWR UP Z=XXX
Enter Selection: 0
1. BASE UNITS=X XX (BASE U
With S CALE 1 SETUP MENU
param eter will be shown. Note that X is the current value and
the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 1 key, the ENTER
value for the base units and then
return to SCALE 1 SETUP MENU #1
8200-M538-O1 225 Installation
SETUP MENU #2
` NEXT
SCALE 1 SETUP MENU #1
6. SAMPLES=XXX
7. STABLE=XX
8. STBL CNT=XXX
9. WT INTERVALS=XX
` NEXT
NITS)
#1 displayed the current setting for the BASE UNITS=
key and then using the numeric keys, enter the
press the ENTER key to save the new setting and
. Allowable values are 0 through 6.
Down Arrow) to proceed to
^ PREV
^ EXIT
XX is the description. If
e
wn.
Page 55