Re-Installing The Rear Panel - Cardinal 225 Installation And Technical Manual

AC Output Relay Board(s), Cont.
Relay Box Assembly RB4-ACOUT or RB8-ACOUT

Re-Installing the Rear Panel

After all terminations have been made;
1. Remove the excess cable from the instrument enclosure and securely tighten each of
the cable gland connectors.
Do not over-tighten these connectors but make certain they are snug.
DO NOT USE TOOLS! Finger-tighten only!
2. Ensure any unused gland connectors are plugged and replace the rear panel.
3. Secure the rear panel with the 14 acorn nuts removed earlier, following a diagonal
pattern when tightening the acorn nuts.
8200-M538-O1 225 Installation
INSTALLATION, CONT.
P16
225 Indicator
Figure No. 10
Page 18