Password - Cardinal 225 Installation And Technical Manual

CALIBRATION AND SETUP, CONT.
Using the numeric keys, enter the value for the new backlight turn-on level and then press
the ENTER key to sa
are: 0 through 99.
NOTE! The valu
BACK LITE=0
Ba cklight always ON

PASSWORD

3. PASSWORD
(PASSWORD)
The password setup parameter determines whether a password is required to enter
Calibration and Setup on indicators programmed for int
indicator is programmed for domestic use (USA=YES) the password parameter W
be displayed on SETUP MENU #3.
W ith the SETUP MENU #3 displayed press the 3 k
will change to show PASSWORD=XXXXXXXXXXXX. Note that XXXXXXXXXXXX is
current password if a password was previously entered, otherwise only PASSWORD= w
be d splayed. i
If the se tting displayed is acceptable, p
using the alpha-numeric keys, enter up to 12 characters for the password and then press
the ENTER key to save the new setting and return to the SETUP MENU #3.
W ith a PASSWORD set, anytime the operator tries to enter Calibration and Setup, the
isplay will show the PASSWORD= prompt requiring the operator to enter the correct
d
password. If the wrong password is
a nd returns to the weight mode. Note that the password is not shown on the display when
t he operator is entering it.
NOTE! It is recommended to write t
lo ation. If the password c
is required, the indicator must be reprogrammed. WARNING! Reprogramming
the indicator will ERASE ALL
8200-M538-O1 225 Installation
ve the new setting and return to SETUP MENU #3. Allowable values
e selected must be less than the Lights= value to activate.
B ACK LITE=99
Back
PASSWORD OPERATION
entered the indicator displays
is forgotten or lost and
light always OFF
ernational use (USA=NO). If the
ey and then the ENTER key. The display
roceed to the next setup parameter. Oth
he password down and store it in a
a change to the indicator setup
the contents of the Nov-Ram and memory.
BACK LITE=XX
Level that backlight
turns ON at
ERROR momentarily
ILL NOT
the
ill
erwise,
secure
U U
Page 73