Setting Up Fax Destination; Setting Up Fax Folder - Oki CX4545 MFP Manual

8.[Administration] Tab Page
Item name
10 Retype Password
 Setting up Fax Destination
You can configure a network folder to store documents that are sent using the Fax driver with the Save as file option
enabled.
1
2
Item name
1 Do not allow any network folder to
be used as a destination
2 Use Network Folder Destination
 Setting up Fax Folder
In the Fax Folder, you can specify in which network folder Fax documents are saved.
1
2
3
4
5
6
7
Item name
1 Protocol
2 Server Name
3 Port Number(Command)
Enter the same password again for a confirmation.
Select this to not allow any network folders to be used as Save as file destinations for Faxes
documents. When selected, users can only save an Fax document with the Save as file
option enabled to local storage.
Select this to allow network folders to be used as Save as file destinations for Fax
documents. When selected, set the Fax Folder settings to specify which network folder to
use.
Select the protocol for uploading an Fax document to a network folder.
 SMB — Select this to send an Fax document to the network folder using the SMB
protocol.
 FTP — Select this to send a file to the FTP server.
 FTPS — Select this to send a file to the FTP server using FTP over SSL.
 NetWare IPX/SPX — Select this to send a scanned file to the NetWare file server using
the IPX/SPX protocol.
 NetWare TCP/IP — Select this to send a scanned file to the NetWare file server using
the TCP/IP protocol.
When you select [FTP] as the protocol, enter the FTP server name or IP address where an
Fax document will be sent. For example, to send an Fax document to the "ftp://192.168.1.1/
user/scanned" FTP folder in the FTP server, enter "192.168.1.1" in this box.
When you select [NetWare IPX/SPX] as the protocol, enter the NetWare file server name or
Tree/Context name (when NDS is available).
When you select [NetWare TCP/IP] as the protocol, enter the IP address of the NetWare file
server.
Enter the port number to be used for controls if you select [FTP] as the protocol. Generally "-
" is entered for the control port. When "-" is entered, the default port number, that is set for
FTP Client by an administrator, will be used. If you do not know the default port number for
FTP Client, ask your administrator and change this option if you want to use another port
number.
8 [Administration] Tab Page
Description
Description
Description
[Setup] Item list 193