8 [Administration] Tab Page
Setting up Energy Save
You can set Energy Save mode for your equipment.
For information on types of Energy Save mode and how to enter the mode, see the Quick Start Guide.
1
2
3
4
Item name
1
Auto Clear
2
Auto Power Save
3
Sleep/Auto Shut Off
The equipment may not enter this mode at the set timing depending on its operational status.
4
Super Sleep
When any of the options such as the Wireless LAN Module, Bluetooth Module or e-BRIDGE ID Gate is installed in this
equipment or when the optional IPsec feature is enabled, you cannot change the Super Sleep Mode from [Disable].
If this equipment cannot be found on the network or cannot be connected via network while in Super Sleep, try searching
again.
The following network settings are required for this equipment to enter the Super Sleep mode.
For models other than those that support color printing, set [Ethernet Speed Duplex Mode] to other than
[AUTO (-1000MB)] or [1000BASE FULL] in the TCP/IP setting.
P.143 "Setting up TCP/IP"
Select [Disable] for [Enable IPv6] or select [Manual] for [Link Local Address] in the IPv6 setting.
P.147 "Setting up IPv6"
Select [Disable] for [Enable IPX/SPX] in the IPX/SPX setting.
P.148 "Setting up IPX/SPX"
Select [Disable] for [Enable Apple Talk] in the Apple Talk setting.
P.148 "Setting up AppleTalk"
Specify one of the following in [POP3 Network Service].
- [Disable] for [Enable POP3 Client].
- No entry for [POP3 Server Address].
- No entry for [Account Name].
- 0 for [Scan Rate].
P.160 "Setting up POP3 Network Service"
Disable IEEE 802.1X authentication.
For the IEEE 802.1X authentication method under the wired LAN environment, refer to the following chapter in the
MFP Management Guide.
Chapter 2: "SETTING ITEMS (ADMIN) - IEEE 802.1X Authentication Setting"
See the following page for network access settings for your equipment in the Super Sleep mode:
P.168 "Setting up Wake Up Setting"
140
[Setup] Item list
Select how long your equipment can remain inactive before the touch panel automatically
returns to the default display.
Select how long your equipment can remain inactive before entering Automatic Energy
Save mode.
Select how long your equipment can remain inactive before being automatically turned off.
Select whether this equipment enters the Super Sleep mode when the specified period has
elapsed in the Automatic Energy Save mode or when the [ENERGY SAVER] button on the
control panel is pressed.
Description