Alternator Rectifier - Triumph Rocket III Service Manual

9. Remove tool T3880201 .
10. Incorporating a new gasket, refit the alternator
cover to the rear of the engine.
11. Tighten the alternator cover bolts to 9 Nm.
12. Incorporating a new a-ring seal, fit the starter
motor and tighten the starter fixings to 27 Nm.
13. Refit the engine as described on page 10.5.
14. Reconnect the battery positive (red) lead first.
15. Refit the rider's seat.
Electrical System
Alternator Rectifier
Note:
• The alternator rectifier is attached to the
battery box. The rectifier does not contain
any serviceable parts and must be
replaced if faUlty.
Removal
1. Remove the rider's seat as described on page
17.9.
2. Disconnect the battery, negative (black) lead first.
3. Remove the left hand side cover as described on
page 17.9.
4. Disconnect both multi-plugs from the alternator
rectifier.
\
1. Rectifier
2.
Multi-plugs
5. Release the two screws secu ring the rectifier to
the battery box and withdraw the rectifier.
Installation
1. Position the rectifier to the battery box and
secure with the two screws. Tighten the screws
to 9 Nm.
2. Reconnect the two multi-plugs to the rectifier.
3. Refit the left hand side cover as described on
page 17.9.
4. Reconnect the battery positive (red) lead first.
5. Refit the rider's seat (see page 17.9).
Service Manual - Rocket III
18.17