Mudguard Embellisher Removal; Embellisher Assembly; Installation - Triumph Rocket III Service Manual

4. Release the mudguard fixings and detach the
mudguard.
1. Mudguard Flxlngs
2. Mudguard
Mudguard embellisher removal
Note:
• To remove the embellisher from the
mudguard, it is necessary to remove the
triangular Triumph sticker. The sticker will
then typically require replacement.
1. Remove the star-washers from each side of the
embellisher, inside the mudguard.
1. Embellisher
2. Star washers
Frame and Bodywork
2. Peel back the triangular Triumph sticker to reveal
the screw head beneath it.
1. Sticker
2. Screw head
3. Release the screw to allow detachment of the
embellisher.
Embellisher assembly
When fitting the mudguard embellisher, it is
necessary to pull the two ends apart slightly, to
avoid damage to the mudguard painted surfaces.
1. Position the embellisher to the mudguard, then fit
and tighten the screw to 3 Nm.
2. Working inside the mudguard, fit star washers to
each side of the embellisher.
3. Thoroughly clean the area beneath the Triumph
sticker.
4. Peel the backing from a new sticker then fix it to
the space on the embellisher.
Installation
1. Manoeuvre the mudguard into position between
the forks.
2. Fit and tighten the mudguard fixings to 27 Nm.
3. Position the mudguard shrouds to the forks.
4. Fit and tighten the shroud fixings to 9 Nm.
5. Refit the brake hoses to the clips on each side of
the mudguard.
~.
Service Manual - Rocket III
17.11