Triumph Rocket III Service Manual page 291

7. Tighten all the header nuts to 19 Nm.
8. Tighten the catalyst box mounting bolt to 27 Nm.
9. Tighten the header to catalyst box clamp bolt to
22Nm.
10. If removed, fit the oxygen sensor and tighten it to
40Nm.
11. Reconnect the oxygen sensor to the main wiring
harness.
12. Fit the isolator rubbers to the tags at the bottom
of the upper heat shields.
13. Position the lower heat shields to the header
pipes.
14. Fit the lower heat shield screws; spring washers
and flat washers, then tighten the screws to
7Nm.
15. Position each of the upper heat shields to the
headers, engaging the isolators in the
corresponding brackets in the lower inner heat
shield.
e/
~ 4
1. Lower heat shield
2. Bracket
3. Isolator
4. Upper heat shields
Fuel System/Engine Management
16. Fit the upper heat shield screws; spring washers
and flat washers, then tighten the screws to
7Nm.
17. Fit new gaskets to each silencer.
18. Position the silencer clamps to each catalyst box
exit.
19. Fit each silencer to the catalyst box and position
to the silencer brackets.
20. Engage the mounting bracket fixings, finger tight.
21. Tighten each silencer bracket fixing to 15 Nm.
22. Tighten each silencer clamp to 22 Nm.
23. Position the heat shields to the silencers.
24. Fit the silencer heat shield screws; spring
washers and flat washers, then tighten the
screws to 7 Nm.
25. Reconnect the battery, positive (red) lead first.
Service Manual - Rocket III
11.137