Inspection; Installation - Triumph Rocket III Service Manual

Cooling
Inspection
1. Remove the pump outer cover to check for
corrosion and scale build-up around the impellor
and in the pump body. Renew if necessary.
2. Check the water pump shaft and shaft bearings
for side and end float. Clean or renew if
necessary.
3.
Check the water pump gland for signs of
leakage. Renew the pump if leakage is evident.
Installation
1. Replace the water pump '0' ring seal.
cbxk
cbxj
1. Waler pump slol
2. Oil
pump shaft, drive blade
3. Fit the pump and tighten the fixings to 10 Nm.
4. Refit the hoses 10 the water pump and tighten the
clips.
5. Reconnect the battery, positive (red) lead first.
6. Refit the rider's seat.
7. Refill the cooling system as described on page
12.7.
1. '0' ring seal
2. Align the drive siot in the water pump with the
drive blade on the oil pump shaft (inside the
crankcase).
coxk
Note:
• The water pump will not engage fully into
the crankcase unless the drive slot and
blade are aligned and engaged.
12.8
Service Manual - Rocket III