Triumph Rocket III Service Manual page 272

Fuel System/Engine Management
o
Installation
Note:
• The opening and closing cables must be
correctly identified and fitted to the correct
positions as noted prior to removal.
cbsz
1. Locate the cables to the frame following the
routing noted du ring removal.
2. Engage the nipples of the inner cables to the
twist grip.
3. Locate the master cylinder to the handlebars.
4. Position the clamp to the rear side of the
handlebars.
5. Align the master cylinder/clamp split line with the
dot mark on the underside of the handlebar.
1. Split line
2. Dot mark
6. Tighten the master cylinder clamp bolts, upper
first and then the lower to 15 Nm.
7. Assemble the switch cube to the master cylinder,
tightening the two screws to 4 Nm.
8. Attach the cable retainer screw and union to the
master cylinder, tightening both to 3 Nm.
11. Release, but do not remove completely, the two
screws securing the master cylinder to the
handlebar.
\
1. Master cylinder
2. Screws
12. Ease the master cylinder away from the
handlebar to allow space for the throttle cables to
be detached from the twist grip. Detach the
cables from the twist grip.
1. Twist grip
2. Throttle cables
13. Note the routing of the throttle cables, then
remove them from the frame.
Examination
1. Check that the throttle cables operate smoothly,
without sticking or binding. Replace the cable if
there is any doubt as to its correct operation.
1. Throttle cables
2. Retainer screw
3. Union
11.118
Service Manual - Rocket III