Drive Shaft - Triumph Rocket III Service Manual

Note:
• Before tightening the bevel box nuts, fUlly
insert the wheel spindle through the
swinging arm to ensure it will realign with
the swinging arm when the wheel is
installed.
Note:
• Bevel box to swinging arm fixings are
tightened in two stages and in a specific
sequence. Tighten all fixings to the lower
torque before progressing to the higher
figure.
Bevel Box and Drive Shaft
3. Align the bevel box by fUlly inserting the wheel
spindle through the bevel box and swinging arm
then, in the order shown below, tighten all the
bevel box nuts to 20 Nm, then to 64 Nm.
Bevel box bolt tightening sequence
4. Refit the left hand rear suspension unit as
described on page 13.5.
5. Refit the rear wheel as described on page 16.9.
6. Lower the motorcycle to the ground and park it
on the side stand.
7. Check and top up the bevel box oil level as
described on page 6.3.
Drive shaft
Drive shaft details can be found in the rear
suspension section on page 13.5.
Service Manual - Rocket III
6.5