Triumph Rocket III Service Manual page 149

18. Temporarily support the rear brake master
cylinder then remove the bolts securing it to the
footrest mounting bar.
=-----=!~
1. Footrest mounting bar
2. Master cylinder bolts
Note:
• It is not necessary to disconnect the brake
pipe from the master cylinder.
19. Unclip the brake pipe.
Engine Removal and Refit
21. Release the fixing securing the brake pipe joint to
the frame outrigger.
1. Brake pipe joint
2.
Bolt
22. Detach the five bolts securing the footrest
mounting bar to the frame and crankcase.
Detach the bar.
When repositioning the rear brake master cylinder,
take car to prevent the steel brake pipe from
becoming distorted.
23. Position the master cylinder, brake pipe and joint
in a safe place, preventing the brake fluid
reservoir from becoming inverted.
24. Select neutral and note the position of the gear
change crank relative to the selector shaft.
(
/fL
c
\ 11
1.
Brake Pipe
2. Clips
20. Remove the heat shield from the brake pipe joint.
r
-,.
-
1 . Gear change crank
2. Selector shaft
25. Remove the bolt from the gear change crank.
Detach the crank.
Service Manual- Rocket III
10.3