Installation - Triumph Rocket III Service Manual

Installation
1. Thoroughly clean and degrease the brake disc.
2. Apply Mobil HP222 grease (or equivalent) to the
wheel driven flange.
3. Position the wheel within the swinging arm.
4. Raise the wheel and engage the driven flange
with the bevel box. Once the splines are
engaged, push the wheel fUlly home.
1. Wheel
2. Bevel box
5. Fit the wheel spindle, pushing it through the
wheel centre sufficient to support the wheel
without preventing fitment of the spacer and
caliper carrier.
1. Wheel spindle
2. Bevel box
WheelslTyres
6. Position the caliper and carrier over the disc
ensuring both brake pads are correctly aligned
either side of the disc.
7. Position the spacer between the wheel and
calliper carrier.
1. Spacer
8. Align the caliper carrier with the wheel spindle,
spacer and swinging arm. Once in alignment,
push the wheel spindle through the caliper
carrier.
9. Align the caliper carrier to the torque reaction
fixing point. Once in alignment, fit a new torque
reaction bolt.
10. Tighten the wheel spindle nut to
110 Nm
and the
torque reaction bolt to 69 Nm.
1. Wheel spindle nut
2. Torque reaction bolt
1\@9R'
Service Manual - Rocket
III
16.9