Assembly; Installation - Triumph Rocket III Service Manual

Brakes
2. Check that the relief and supply ports on the
cylinder are not blocked.
cb~m
1. Ports
Assembly
Never use mineral based grease in any part of the
braking system or in any area where contact with
the braking system is possible. Mineral based
grease will damage the hydraulic seals in the
calipers and master cylinders. A dangerous riding
condition leading to loss of motorcycle control and
an accident could result if this warning is ignored.
1. Lubricate the piston and cylinder with new, clean
brake fluid.
Ensure that the piston and piston seal are fitted
facing the same way as noted during removal. A
dangerous riding condition leading to loss of
motorcycle control and an accident could result from
incorrect assembly of the master cylinder.
2. Fit the new piston set into the master cylinder
and retain with a new circlip.
1. Piston
2. Seal (in correct orientation)
3. Refit the master cylinder dust cover.
Installation
1. Locate the master cylinder to the handlebars.
2. Position the clamp to the rear side of the
handlebars.
3. Align the master cylinder/clamp split line with the
dot mark on the underside of the handlebar.
2~
e
\II.:".,....--;~ ~
=
1. Split line
2. Dot mark
4. Tighten the clamp bolts, upper first and then the
lower to 15 Nm.
15.18
Service Manual - Rocket III