Installation - Triumph Rocket III Service Manual
Hide thumbs
Also See for Rocket III:
- Handbook (104 pages) ,
- Manual (104 pages) ,
- Owner's handbook manual (102 pages)
Table of Contents
Advertisement
5.
Release the three Torx fixings securing the input
shaft bearing housing to the upper crankcase.
1. Input shaft bearing housing
2. Torx fixings
6.
Insert two M6 bolts into the two threaded holes at
the periphery of the bearing housing. Evenly and
progressively tighten both bolts to draw the
bearing housing from the crankcase.
1. M6 bolts
2. Bearing housing
7.
With the bearing housing released, withdraw the
input shaft through the aperture for the bearing
housing.
Installation
1.
Locate the input shaft to the upper crankcase,
installing it through the aperture for the bearing
housing.
2.
Fit the bearing housing into the aperture, by
hand, as deeply as possible.
3.
Using the old Torx fixings, draw the bearing
housing into the upper crankcase until fully
home. Remove and discard the Torx fixings.
Transmission
4.
Fit new Torx fixings to the bearing housing.
Tighten them to 12 Nm.
5.
Using a small punch, stake the Torx heads to the
corresponding notches in the upper crankcase.
1. Torx fixings
2. Notches
3. Stake marks
6.
Refit the selectors and shaft as described on
page 8.9.
7.
Refit the output shaft to the crankcase ensuring
the snap-ring on the outside of the inner bearing
locates in their corresponding groove in the
crankcase.
Installing the Output Shaft
8.
Assemble the crankcases as described on page
5.9.
9.
Refit the engine to the frame as described on
page 10.5.
~.
Service Manual - Rocket
III
8.13
Advertisement
Chapters
Table of Contents
