Triumph Rocket III Service Manual page 118

Transmission
10. Feed the gear change shaft through the
crankcase, engaging it in the actuator arm and
also attaching the free end of the detent arm
spring over the spring abutment bolt. Ensure that
the gear change return spring also engages over
the spring abutment bolt.
=="'='=-
="'==-
1. Detent arm spring
2. Spring abutment bolt
3. Gear change return spring
11. Fit a new bolt to the gear change actuator and
tighten it to 28 Nm.
Note:
• If a new bolt cannot be sourced, clean the
threads of the old bolt and apply a spot of
three-bond 1305 to the threads before
fitting it.
12. Refit the input shaft as described on page 8. 13.
Note:
• Selector forks are marked A, Band C. The
marking letters always face the clutch end
of the input shaft.
13. Place the transmission in neutral. The
transmission is in neutral when the wheel of the
detent arm rests in a tooth on the detent wheel
that has a V-shaped cut-out.
1. V-shaped cut out
2. Detent arm
14. Partially insert the selector shaft into the
crankcase.
15. Position and support the selector forks in the
selector drum as noted or marked prior to
removal.
1. Selector forks
2. Selector drum
3. Selector shaft
16. Feed the selector shaft through the selector forks
and secure it with a new 'C' clip.
17. Assemble the crankcases as described on page
5.7.
18. Refit the engine as described on page 10.5.
8.10
Service Manual - Rocket III