Installation; Clutch Cover; Removal; Clutch - Triumph Rocket III Service Manual

Clutch Cover
Removal
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
1.
Remove the radiator as described on page
12.11.
2. Remove the water pump as described on page
12.7.
3. Remove the coolant pipe running between the
crankcase and water pump.
4. Disconnect the clutch cable as described on
page 4.5.
5. Release the ring of bolts securing the clutch
cover to the crankcases.
6.
Place an oil catch tray beneath the clutch cover
to collect any oil that may spill out on removal.
7.
Carefully withdraw the cover disengaging the
litter arm as it is eased forward.
Installation
1. Thoroughly clean the cover and crankcase
mating faces.
2. Position a new gasket to the crankcase.
3. Refit the cover ensuring that the gasket does not
become dislodged.
Note:
• Ensure that the litter piece engages
correctly with the litter arm during
assembly. It way be necessary to pull the
litter arm forward to allow assembly to take
place.
4. Fit and tighten the bolts to 9 Nm. Tighten the
bolts in a diagonal sequence.
5. Refit the coolant pipe, tightening its fixing to
9Nm.
6. Refit the water pump as described on page 12.8.
7. Refit the radiator as described on page 12.13.
Clutch
Clutch
Removal
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
1. Remove the clutch cover as described on page
4.5.
2. Undo the bolts, withdraw the springs and remove
the clutch pressure plate.
1. Pressure plate bolts
2. Springs
3.
Pressure plate
3. Remove the litter piece, needle bearing and
thrust washer.
1. Llfler piece
2. Needle bearing
3.
Thrust washer
Service Manual - Rocket III
4.7