Removing A Cd-Rom Disc From A Drive - HP Model 745 - VME Workstation Owner's Manual

Figure 8-4
NOTE:
8-8
Using Mass Storage Devices
Operating the CD-ROM Drive
Unloading a CD-ROM Disc
Perform the following steps to unload a disc from the CD-ROM drive:

Removing a CD-ROM Disc From a Drive

1 Press the eject button to eject the disc tray from the drive. If the drive is in use,
you must press the eject button for more than one second to eject the disc tray.
You must unmount the disc before ejecting it from the drive. Refer to the
subsection, "Unmounting a CD-ROM Disc Using SAM," for instructions on
unmounting a disc.
Wait until the drive has fully ejected the disc tray, then remove the disc
2
from the tray as shown in
the disc.
To close the Disc Tray, push the front of the disc tray gently towards the
3
drive until it closes by itself.
. Be careful to touch only the edges of
Figure 8-4