Tools Required And Preliminary Procedures; Tools Required For Installation; Preliminary Procedures - HP Model 745 - VME Workstation Owner's Manual

Tools Required and Preliminary Procedures

Tools Required for Installation

All parts can be accessed with these tools:
Static grounding wrist strap
No. 1 Pozidriv screwdriver
Small flat-tipped screwdriver
5mm (3/16-inch) nutdriver (RAM standoffs require this tool)

Preliminary Procedures

Perform the following steps before installing or removing accessories:
1 Exit application programs.
2 Shut down the operating system and power off the chassis. (See Chapter
3 for detailed instructions.)
3 Remove all cables connected to the board computer.
4 Set up a static-free place on which to work.
Processor Options Installation
Tools Required and Preliminary Procedures
4-3