Cd Rom Drive; Removing The Cd Rom Drive - HP Visualize B1000 Supplementary Manual

CD ROM Drive

This section describes how to remove and replace the CD ROM Drive

Removing the CD ROM Drive

NOTE Prior to removing the CD ROM Drive, the Front Panel and the Left Side
Panel need to be removed. See the appropriate section(s) for the steps to
remove and replace these components.
1. Remove the two T-15 Torx screws that secure the CD ROM drive tray to the front of the
chassis.
Figure 2-20. CD ROM Drive Removal: External
T-15 Torx Screw
2. Facing the opened side of the workstation, remove the T-15 Torx screw that secures the
back cover of the CD ROM Drive bay, and then remove the back cover. Reach into the
back of the CD ROM Drive bay and disconnect the three cables: the CD ROM Drive
power cable, the ATAPI data cable (the ribbon cable), and the CD ROM audio cable.
Disconnect these same three cables from the system board and set them aside.
Chapter 2
Parts Removal and Replacement
CD ROM Drive
T-15 Torx Screw
25