Testing The Printer Installation; Hp Parallel - HP Model 745 - VME Workstation Owner's Manual

NOTE:
18 Enter the following to exit root and return to user status:
exit Enter
Refer to System Administration Tasks for additional SAM information.

Testing the Printer Installation

If you made your printer the default system printer, type the following com-
mands to test it:
cd Enter
lp .profile Enter
If your printer (called printername) is not listed as the default system printer,
enter the following command to test it:
lp -dprintername .profile Enter
The file named .profile should print out on your new printer.
For information on printer-related problems, see Chapter 9 of this book.

HP Parallel

The parallel port is compatible with Centronics® standards, plus some addi-
tional features found in HP Series 700 workstations. It supports a bi-direc-
tional register model interface in addition to printer-only DMA. Series 700
Scanjet interfaces are not supported.
A high-density micro D-sub connector is used for the HP Parallel interface.
An HP A4300A conversion cable is required to convert to a standard PC
compatible 25-pin female D-sub cable.
Figure 2-10 shows the HP parallel connector. Also refer to Figure 2-1.
Connecting Cables
Printer Connections
2-21